Attract Nosiboo Mode D'emploi page 3

UM_USA_User Manual_Colibri 18/11/16 16:03 Page 3
Always wash the Colibri head after use.
Read and follow the instructions of the "Environment" section if you
would like to dispose of the device or any part of it.
Do not insert the nose tip into the baby's mouth or ears.
Do not force or insert the nose tip too far into the nose.
Do not press the tip against the side of the nostril.
Do not use if nasal sores, inflammation or nosebleed are present.
If pain or bleeding occurs, stop use immediately and consult your
doctor.
Do not use the Colibri head and the device without the collared tube.
Make sure that all parts are dried thoroughly before the next use.
Do not use more than a teaspoon of saline solution at a time.
Keep away from heat.
1. Intended use
For aspirating nasal mucus from a child's nose. The vacuum needed for the
aspiration is created by the user's mouth (in an indirect way thanks to the
detached design).
Intended purpose: removing nasal mucus from the baby's nose to prevent
complications caused by childhood colds and to accelerate the healing
process.
Recommended for: relieving symptoms of the common cold.
2. Device introduction and assembly
The aspirated liquid accumulates on the inner wall of the Colibri head.
Thanks to its exclusive patented design, the liquid cannot exit from the inside
of the Colibri head, safely preventing the nasal mucus from getting into the
connecting tube or into the mouth of the person performing the suction.
There is no need for a filter!
The Nosiboo Nasal Aspirator can hold up to a teaspoon of thin liquid.
Assembly
1. Clean the parts of the Colibri head (see chapters "Cleaning" and
"Maintenance and storage").
2. Insert the collared tube into one half (the half with connector) of the
Colibri head.
3. Put the other half of the Colibri head (without connector) on the first half.
4. Push the flexible nose tip on the matching flange.
5. Attach one end of the connecting tube to the Colibri head
connection point.
6. Attach the other end of the connecting tube to the mouthpiece.