Print Function - KERN MCB Mode D'emploi

Printout from PRE-
TARE memory  Press
Example:
M1 0.0 kg
M2 7.0 kg
M3 10.0 kg
M4 30.0 kg
M5 50.0 kg

12.6 Print function

This action requires the RS232 interface cable available as an accessory which has
to be connected via the round plug to the rear end of the terminal.
(Loosen the two screws from the side, take off the display unit, insert the cable and
screw the display unit back on.)
In a medical context only auxiliary equipment in compliance with
Directive EN 60601-1 may be connected to the interface.
Pressing the PRINT – key whilst the scales are in weighing mode will trigger a
printout of the determined data via the interface, as described in the following.
This is a standard output that cannot be modified.
Example:
G 88.8 kg Gross weight
T 2.0 kg Taring weight
N 86.8 kg Net weight
180.0 cm Size of patient
24.4 BMI BMI value
42
PRE-
TARE
and hold until "ni" (M) appears on the display.
 To issue the values saved to the 5 memories, briefly press
PRINT
the button.
MCB_MPT-BA-e-1619