Service And Repairs; Warranty Conditions - Hayward Pool S244SXE Pro Guide De L'utilisateur

THE FLOW FALLS OFF AND/OR
THE PRESSURE GAUGE READING
EXCEEDS THE INITIAL PRESSURE
BY 10 PSI ( 0,7 bars or kg/cm
1. Check and empty the skimmer
andpump pre-filter baskets.
2. Check that there is nothing pin-
ching or pluging the water intake
and return hoses.
3. Check that there is no leak in the
water intake hose (shown up by
air bubbles in the water returned
to the pool).
4. Backwash the filter.

SERVICE AND REPAIRS

Consult your local dealer. No return may be made directly to the factory without the express written
authorization of Hayward Pool Europe.
If malfunctioning continues, or for any other operating fault, contact your retailer-installer.
It is expressly stipulated that HAYWARD cannot be held responsible for any damage caused by its
equipment if such damage is caused by non-conforming repairs whenever, during the replacement of
parts, HAYWARD original parts were not used and if repair was not performed in conformity with HAY-
WARD instructions or if the information in this guide was not complied with.
This is also valid for any addition of parts and accessories other than those recommended by HAYWARD.

WARRANTY CONDITIONS

HAYWARD warrants its products free from defects in material and workmanships for a period of one
year from the date of purchase. A purchase proof with its date must be enclosed for any request for
warranty. We invite you to keep your receipt.
HAYWARD warranty is limited to the replacement or repair, at its option, of defective products that have
been used in normal conditions and according to the instructions leaflet, with no change in the product
and that have been working only with genuine HAYWARD parts. Frost and chemical reaction damages
are excluded of the warranty.
HAYWARD will not be responsible for any other costs (removal, labor...), neither direct or indirect
damages caused by malfunction of a product.
To initiate a warranty claim and ask for repair or replacement of a product, please contact your dea-
ler. No shipment to our factory will be accept without our preliminary written acceptance.
Wear parts are exclued of the warranty.
Product with warranty extension : Polyethylene tank (sand filter) 5 year.
LIST OF POSSIBLE PROBLEMS
IT BECOMES NECESSARY TO
CLEAN MORE AND MORE OFTEN
2
).
1. Check the pool for algae an if
necessary add disinfectant.
2. Check that the disinfectant level
and pH are correct (adjust if
necessary).
3. Check that the surface of the
sand has not solidified or
become clogged (if so, remove 2
or 3 cm of sand).
:
6
1. Check the disinfectant level, pH,
2. Make sure that the filtration flow
3. Run the filter longer.
4. Make sure that the valve is set to
5. Make sure that your installation is
THE POOL WATER DOES NOT
BECOME CLEAR
and total alkalinity and adjust if
necessary.
is correct.
" Filter" .
properly connected.