USRobotics 5436A Guide D'installation Rapide page 8

English
Step Three: Print a Test Page
1. Windows XP, 2000, and NT Users:
o
Click Windows
Windows Me, 98, and 95 Users:
1) Click Windows
2) Within Control Panel, click
2. Right-click the printer you just installed and select
3. Click
Print Test Page
does not print a test page, refer to the "Troubleshooting" section in this
guide.
Step Four: Setup the Print Server for Wireless Access
You can now access the wireless functions of the Wireless USB Print Server.
1. Disconnect the Ethernet cable and the power adapter from the print server.
2. Reconnect the power adapter to restart the print server. The print server
should now establish a wireless connection to your wireless router or access
point.
3. Repeat the instructions from Step Three: Print a Test Page.
If you are unable to print the test page, there is a problem with your wireless
connection. Refer to the Troubleshooting section in this guide.
Step Five: Connect Clients to the Wireless USB Print Server
To allow other computers on your network to print using the Wireless USB Print
Server, you must perform the client installation procedure on each computer.
N o te : You may need the Installation CD-ROM that came with your printer.
1. Insert the U.S. Robotics Installation CD-ROM into the CD-ROM drive.
2. Click
Additional Installs
3. Select and then follow the on-screen instructions to install the print
User
server software.
4. When prompted, select the printer and click
5. Select the printer from the
" If the printer doesn't appear, click
screen instructions.
6. Click .
Close
Congratulations. You have successfully completed the installation procedure.
Please register your Wireless USB Print Server at www.usr.com/productreg/.
4
>
Start Printers and Faxes
>
Start Settings
Printers and Faxes
. Your printer should successfully print a test page. If it
and then click
Existing Printers
Add New Printer
.
>
.
Control Panel
.
Properties
.
Next
.
Next
list.
and follow the on-
.