Operating And Safety Instructions - Unitec 77 089 Mode D'emploi

77089 Bed.:Lay 17.05.2010
Welcome
Note on safety
Fitting instructions:
4
12:17 Uhr Seite 4

Operating and safety instructions

These LED marker light from UNITEC have been carefully designed and manu-
factured to ensure all-round reliability. Before using your LED marker light,
please read carefully through these instructions, which contain all you need to
know in order to ensure that your LED marker light give you many years of relia-
ble service. Please keep the instructions in a safe place for future reference.
Please observe the permitted installation-width
and height limits (see plan). The two LED lamps
must be fitted at least 600 mm apart from one
another. Be sure to observe the maximum distan-
ce of 400 mm between the side of the LED lamp
and the outer edge of the vehicle's wing. The
minimum distance between the LED lamp and the
roadway is 350 mm. The maximum installation
height with respect to the roadway is 1500 mm. Both lamps must be at the same
distance from the roadway and their respective sides of the vehicle.
• Switch off the ignition and engine while working on the vehicle.
• Make sure that no rotating parts can come into contact with the cables laid
and that the cables cannot be damaged by the effect of heat.
• Deactivating the standard parking lights/marker lights may lead to error mes-
sages in your vehicle (OBD, onboard diagnosis). Please contact a specialist
garage.
• If you have doubts or reservations about your own skills during installation,
please contact a specialist garage.
1. Determine the ideal installation position for the LED marker light on the basis
of the installation diagram above.
2. Lay the connection cable in the installation position previously selected.
3. Connect the marker light to the connection cable.
4. Fix the marker light to your vehicle with the attachment equipment supplied.
5. Connect the red cable to your existing marker/parking light.
6. Connect the black cable to your vehicle's earth/negative pole.
7. Permanently deactivate your vehicle's standard front parking lights/marker
lights.