König Electronic SEC-PH380 Mode D'emploi page 5

5
A. Peel off the tape on the backside of the metal plate. This
will help to prevent scratching the door while mounting the
metal plate and the monitor.
6
Insert the metal tube into the hole and make sure that
the flat connection cable is coming through the opening
of the metal tube.
Circuit board
B. Align the hole of the metal plate over the hole in the door
and place the metal plate on the door. Make sure that the flat
connection cable is coming through the hole of the metal
plate.
Note: Make sure that the circuit board is placed in the right
top corner.
5