Table des Matières
Publicité
Anleitung_EH_100_SPK7__ 24.02.14 15:42 Seite 10
GB
5. Technical data
Voltage
Power consumption
Cutting length
Cutter rail length
Tooth spacing
max. cutting ø
Cuts/min
Sound pressure level L
pA
Sound power level L
WA
K uncertainty
Vibration on steady grip a
Vibration in handle a
hv
K uncertainty
Weight
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
10
230V ~ 50Hz
500 W
410 mm
450 mm
16 mm
12 mm
3500
75.96 dB(A)
95.96 dB(A)
3 dB(A)
2.785 m/s
hv
3.298 m/s
1.5 m/s
2.3 kg
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
The electric power tool generates an electromagnetic
field during operation. Under certain circumstances
this field may actively or passively impede medical
implants. To reduce the risk of serious or fatal injuries,
we recommend persons with medical implants to
consult their doctor and the manufacturer of the
medical implant prior to using the equipment.
6. Before starting the equipment
2
Before you connect the equipment to the mains
2
supply make sure that the data on the rating plate
2
are identical to the mains data.
Fitting the hand guard (Fig. 3a-3b)
Attach the hand guard (Fig. 3a/Item 2) in the direction
of the arrow as shown in Figure 3a. Then secure with
the two screws (Fig. 3b/Item 8).
7. Operation
The hedge trimmer is equipped with a two-handed
safety switch. The machine works only when the
switch on the steady grip (Fig. 4/Item A) is pressed
with one hand and the switch on the handle (Fig.
4/Item B) is pressed with the other hand.
Releasing any of the switches will bring the hedge
trimmer to a stop.
In so doing, please check the running of the
blades.
b
Please check that the blades function correctly.
The blades cut on both sides and run in opposite
directions to each other, for guaranteed high
cutting performance and quiet operation.
b
Fasten the extension cable to the cable holder
before starting to use the machine (see Fig. 4).
b
For use in the open air you must only use
extension cables certified for the purpose.
Tips on use
b
The hedge trimmer can be used not only for
trimming hedges but for trimming shrubs and
bushes as well.
b
For optimum trimming performance, guide the
blade teeth at an angle of approx. 15° to the
Publicité
Table des Matières
