Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Rubber washers
Conical counterstuck head
Holed cylinder
Assembly
On each bar :
- Tighten the nut M8 on the bar until the end of the thread.
- Assemble the rest in the following order : 1 wide conical washer Ø 8,5, 2 steel half-cylinders (held together by O-ring
in the furrow), 1 narrow conical washer Ø 8,5 and 1 Nylock nut M8 (see draw).
- Insert the bar (the side previously assembly) into the provided hole on the original handle bar of the scooter. Then,
once in full lock, tighten the long nut.
- Place the 4 holed cylinders on both bent fitting bars.
On the windshield :
- Enter the screw in the chrome washer, then the rubber washer, the windshield and the other rubber washer.
- Screw the windshield on the holed cylinders and tighten the screws once the windshield adjusted with the outline of
the headlight.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjusting to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* In order to increase longevity of your chromed fixings, it is advised to polish them off with an anticorrosion product as WD40 ® after each washing or exposition at humid atmosphere (rain ...).
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
®
Sportivo
screw
Chrome washer
ERMAX WINDSHIELD ADAPTABLE ON
VESPA 50/125 SPRINT& PRIMAVERA 2014 → ∞
- Mini Sportivo
Fitting kit
- 4 conical counterskunk head screws 6x20
- 2 bent chrome fitting bars Ø10
- 4 steel half-cylinders
- 4 chrome washers Ø6
- 2 Nylock nuts M8
- 4 holed cylinders L: 30mm (for bars)
- 2 conical wide washers Ø8,5
- 2 nuts M8
- 2 narrow conical washers Ø8,5
- 2 O-rings Ø17
- 8 rubber washers Ø6
Half cylinder
Nylock nut M8
« CAUTION »
FITTING INSTRUCTIONS
®
- Piccolo
O-ring
Conical washer
®
Nut M8
Publicité
