Led Indicators; Technical Specifications - IVT FS-02 Notice D'utilisation

CONNECTION AND STARUP PROCEDURE
Connect the remote control FS-02 using the supplied cable to the corresponding socket of your DSW inverter. As soon as
the two devices are connected, the remote control is ready for use. The voltage converter serves for supplying the remote
control with the required current.
You may switch on/off the inverter both directly on the voltage converter and with the FS-02.
Please ensure that the inverter is switched on even if only one of both switches (on the device or on the
remote control) is set to the corresponding position (ON).
If you intend to use the remote control, the main switch on the inverter must be in the "OFF" position.
Then, you may use the remote control as required.
The inverter is shut down completely (without current) only if both switches on the voltage
converter and on the remote control (1) are in „OFF"position!
The plug in for the connection wire is at the backside of the device.

LED INDICATORS

The LED status indicators for DC input and AC output provide important information on the operating status of your
converter. Both LEDs work independently from one another. A failure in the DC input area has direct impact on the function
of the AC output; or a failure in the output area affects the input function directly.
Operating status/ fault indicators
Device is switched on and ready for operation
Early warning for deep discharge protection
Cut-off due to deep discharge protection
Overvoltage on the input
Short-circuit or overload on output

TECHNICAL SPECIFICATIONS

Connection cable length: 4,0 m
Dimensions:
Weihgt:
Item No:
ENVIRONMENTAL PROTECTION NOTE
At the end of its useful life, this product must not be disposed of together with normal household waste,
but has to be dropped off at a collection centre for the recycling of electrical and electronic devices. This is
indicated by the symbol on the product, on the instruction manual or on the packaging.
The materials of which this product is made are recyclable pursuant to their labeling. With the reuse, the
recycling of the materials or other forms of scrap usage you are making an important contribution to the
protection of the environment. Please ask your local administration office for the appropriate disposal
center.
Technical specifications are subject to change. We assume no liability for typographical errors V2_06/2017
Phone: 09622-719910, fax: 09622-7199120; info@ivt-hirschau.de;
3
1 2
85 x 47 x 24 mm
40 g
430121
IVT Innovative Versorgungs-Technik GmbH, Dienhof 14, D-92242 Hirschau
1. On/Off switch
2. Status LED for AC output
3. Status LED for DC input
LED for DC input (3)
Lights up
Slow blinking
Fast blinking
Fast blinking
Fast blinking
5
LED for AC output (2)
Lights up
Lights up
Fast blinking
Fast blinking
Fast blinking
www.ivt-hirschau.de