Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
EN
3. OPERATION
Plug the Patio Heater into a grounded 220V-240V, 50-60Hz power outlet.
IMPORTANT:
• The heater must be properly installed before it is used .This unit is
equipped with one heat setting On I Off.
• Although the patio heater is waterproof, do not use when raining or in
wet conditions.
• Only operate the heater when it is in the upright position.
• Always disconnect the power cable from the electrical supply, when the
patio heater is not in use.
Our Electric Patio Heater is equipped with with three power settings; 900 W, 1200 W and
2000 W.
1) Press the On/Off button to turn the heater on or off .
2) Press the button once to operate the heater on low (900W) power.
3) Press the button twice to operate the heater on medium (1200W) power.
4) Press the button three times to operate the heater on maximum (2100W) power.
5) Press the button four times to turn off the resistances and stop the emission of heat.
4. MAINTENANCE
• Unplug the unit and let it cool completely.
• To keep the heater clean, the outer shell must be cleaned with a soft, damp cloth. You
may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to
clean the heater. This may cause damage or deterioration to the surface of the heater.
• Although this heater is outdoor approved, DO NOT immerse the heater in water for
your safety.
• Wait until the unit is completely dry before use.
• If the heater will not be used for a long period of time, store it in a cool, dry location
when not in use. To prevent dust and dirt build-up, use the original packaging to repack
the unit.
NEVER USE SOLVENTS OR ABRASIVE PRODUCTS.
20
PH-21
Publicité
Table des Matières
