Water Filtration System; Water Filter Status Light - Viking P2WG2 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Refrigerator Use
Removing and Replacing Ice Storage Bin
1. Hold the base of the storage bin with both hands and press the release button to lift the storage bin
up and out.
NOTE: It is not necessary to turn the ice maker control to the OFF (right) position when removing the
storage bin. The sensor cover ("flipper door") on the left wall of the freezer stops the ice maker from
producing ice if the door is open or the storage bin is removed.
2. Replace the storage bin on the door and push down to make sure it is securely in place.

Water Filtration System

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfec-
tion before or after the system.

Water Filter Status Light

The water filter status light will help you know when to change your water filter. When the water filter
status display changes from "GOOD" to "ORDER," this tells you that it is almost time to change the
water filter cartridge. Replace the water filter cartridge when the water filter status display changes to
"REPLACE." If water flow to your water dispenser or ice maker decreases noticeably, change the filter
sooner. The filter should be replaced at least every 6 months depending on your water quality and
usage.
After changing the water filter, reset the status light by pressing and holding the FILTER button for 3
seconds. The status light will change from "REPLACE" to "GOOD" when the system is reset.
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

P2wg2lP2rfwg2

Table des Matières