Targus Stow-N-Go Manuel De L'utilisateur page 6

Establishing a Communications
Link
After your computer detects the USB receiver and the
default driver software is installed, you may need to
establish a communications link between the receiver and
the keypad before you can use it.
1 Plug the receiver into your computer's USB port and turn
on the keypad.
NOTE: MAKE SURE THAT YOUR COMPUTER AND KEYPAD ARE TURNED ON AND
YOUR COMPUTER HAS DETECTED THE USB RECEIVER BEFORE YOU ESTABLISH
A COMMUNICATIONS LINK.
Connection
Button
On/Off Switch
The LED on the receiver will fl ash for 60 seconds to
indicate ID search mode.
Targus Wireless Stow-N-Go Calculator Keypad