Targus Stow-N-Go Manuel De L'utilisateur page 5

Connecting
Installing the Default Drivers
To connect the receiver:
1 Remove the receiver from the back of the keypad.
2 Plug the USB receiver into an available USB port on
your computer.
For Windows® 2000/XP/Vista, the "Found New Hardware"
or "Auto-detect of a HID device" message will appear to
indicate the installation of the default driver.
NOTE: YOU MAY NEED TO ESTABLISH A COMMUNICATION LINK BETWEEN THE
KEYPAD AND THE RECEIVER. SEE "ESTABLISHING A COMMUNICATIONS LINK"
.
Turning the Calculator/ Keypad On
and Off
To power on the batteries, use the on/off switch located
on the back of the keypad.
To turn on the keypad, press the CE/AC key, located
directly above the number seven key.
To turn off the keypad in calculator mode, press the CE/
AC key for 2 seconds.
To power off the batteries, use the on/off switch located
on the back of the keypad.
Targus Wireless Stow-N-Go Calculator Keypad
the Receiver and