Cleaning And Maintenance - AMBI SPHERE 8 m x 3 m Série Mode D'emploi

GB
Instructions
Select a at surface for the tent. Unpack the boxes and check if all listed parts are included.
with a cloth. In colder weather conditions we suggest to bring the roof to room temperature before installing.
1
Assemble the roof frame by moun ting parts 7 to 12 on the pipes (parts 2 and 3). Use the screws to attach the parts.
2
Attach the reinforcement braces (parts 4 and 5) using screws (29) and wing nuts (31).
Fastening the roof by using turnbuckle se t (18) which is diagonally across through each tw o section as below .
3
Lift one side of the tent frame and attach the legs (6). Place the roof (34) onto the frame and use the bung ees (23) to fasten it.
Be sure not to put too much tension on the bung ees in order not to make attaching the other side mor e dif cult.
4
Attach the legs on the other side and ins t all the feet (13, 14, 15) a t the bottom. Use the long gr o und pegs (21) to fasten the feet
to the ground. Attach the side covers to the pipes (1) using hook s (26). Make sure, that the leg pipes are in vertical position, to avoid
overtention on the endwalls. Using turnbuckle se ts (17) to fasten the structure just the same as you do on roof.
Complete the bottom frame with the required pipes (2) and connector (16).
5
Unfold the side walls (35) and the end walls (36) and attach the side walls to the frame using the bung ees (23). Attach the end
walls directly to the roof using the short bung ees (24). Use the short ground pegs (22) to fasten the end walls to the ground.
The guy rope runs from every corner of the tent and is braced to the ground using the scr e w hooks (20). The professional
ground pegs (19) pr ovide the tent with additional tension and stability.

Cleaning and maintenance

Wash off the roof and the side parts with soapy w ater. Mould and mould stains can be removed using a mild
chlorine solution. Observe the instructions provided by the manuf a cturer and test the chlorine solution on a
hidden spot to make sure that there is no discolouration.
Caution! The party tent must not be dismanteled and pack ed up when it is wet. First, allow it to dry completely.
Caution
1. Always handle the tent with care to avoid damag e.
2. Do not apply too much pressure to the frame parts to avoid damag e.
3. Tents are intended for temporary accommodation and should be t a ken down in adv erse weather
conditions.
4. Always be sure to keep suf cient distance to hoses as well as gas and power lines to avoid possible
damage.
5. When using suitable heaters (available e.g. in specialist shops), keep a minimum dis tance of 1.2 m to tarp
material. Open re or heaters with open ames such as pa tio heaters, umbrella heaters, gas heaters etc.
should not be used in an y case.
6. The person setting up the tent is responsible for adequately securing it to ensure its safety.
Remove the slight oil lm from the pipes
®
8