intercable STILO 45 Manuel D'utilisation page 16

4. Spare parts
5. Conduct in case of faults
Only original Intercable spare parts may be used.
Battery: RA12
Battery charger:
In case of any fault, the Power Tool will be switched off and remain disabled. The service
LED will glow red or orange. You can proceed with your work only after the battery has been
exchanged or removed for short time and is then re-inserted (RESET). If the malfunction
persists even after such a "reset", please contact Intercable after-sales service.
5.1 Codes of the operating/service LED display
16
The fault massages can be read out using the analysis software. Please return the faulty
working diagrams to our service center.
5.2 Codes of the supply voltage LED
LED-Display
after application (cycle)
steady green
steady red
steady orange
after power on (battery insertion)
steady green
steady orange
steady red
LED-Display
after application (cycle)
steady red
after power on (battery insertion)
steady green
steady red
LG8
Cause / remedy
Working value OK
Working value OK but service interval exceeded / Service
Working value is at the limit / contact the service center
Working value is outside range / return device to customer service
Temperature is outside the tolerance range /
cool or warm the device
Power tool is ready for operation
Temperature is outside the tolerance range /
cool or warm the device
Battery empty / change the battery.
Cause / remedy
Battery charge is below 10% / Change the battery.
Battery empty / change the battery.
Power tool is ready for operation
Battery empty / change the battery.
STILO 45