Symbols Used; Safety Instructions; Intended Use - Truma PS 100 Automatic Mode D'emploi

Electrical ballast PS 100 (200) Automatic
Operating instructions
Please be sure to read the instructions for installation and
use before attempting to connect and use this device!

Symbols used

Symbol indicates a possible hazard.

Safety instructions

To protect you from electrical shocks, injury or burns
the following basic safety principles must be observed
when using electrical devices. Please read and follow these
instructions before using the device.
Installation
Ensure that the devices are positioned safely and cannot fall
down or over. Always position the cables to ensure they do
not pose a tripping hazard. Do not expose electrical devices to
rain. Do not operate electrical devices in damp or wet environ-
ments. Do not operate electrical devices close to flammable
liquids or gases. Position the devices so that they are out of
the reach of children.
Protection against an electrical shock
Only operate devices whose casings and cables are undam-
aged! Ensure the cables are installed safely! Do not pull on
the cables!
8
Only operate the device if it has been secured with
a 30 mA fault-current circuit breaker. Observe the
EVU-regulations.
Use
Do not use electrical devices for purposes other than those
stated by the manufacturer.
Repairs
Do not repair or modify the device. Please contact your dealer
or the Truma Service (see service manual or www.truma.com).
Accessories
Only use accessories and additional devices that are supplied
or recommended by the manufacturer.

Intended use

The electrical ballast PS 100 (200) Automatic is a power sup-
ply device for 12 V consumers (e.g. water pumps, ventilators,
light bulbs etc.) from the 230 V AC voltage network. The
device is designed for installation in caravans, campers and
boats.