Delta 31-735 Manuel D'utilisation page 21

SANDING INSIDE CURVES
Disconnect the machine from the power source!
1. Loosen the two lock knobs (A) Fig. 58 and remove the top cover (B).
2. Inside curves can be sanded on the top sanding drum (Fig. 59).
Fig. 58
Replace the top cover (B) Fig. 58 when done.
END SANDING WITH THE BELT
When you sand the ends of wide workpieces, use the
sanding arm in the vertical position as shown in Fig. 60.
P o s i t i o n t h e e d g e o f t h e t a b l e
a maximum of 1/16" away from the sanding belt
to avoid trapping the workpiece or your fingers
between the table and the sanding belt.
SANDING OUTSIDE CURVES
Sand outside curves on the sanding disc as shown in
Fig. 61.
Sand on the left (downward) side of the sanding disc (Fig. 61). Sanding on the right (upward) side
of the sanding disc could cause the workpiece to be thrown upward and could cause personal injury.
Position the edge of the table a maximum of 1/16" away from the sanding belt to avoid trapping
the workpiece or your fingers between the table and the sanding belt.
B
A
21
Fig. 59
Fig. 60
Fig. 61