Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1
Make sure that no units are powered before starting the installation procedure.
2
Remove the CCD cover.
3
Fit the lens on the camera.
4
Connect the wire to the AUTO-IRIS connector .
5
Connect the CCTV camera to the other devices of the system using an approved 75 ohm coax cable.
6
Power the camera.
7
Make the adjustments required (see paragraph below)
FOCUSING PROCEDURE FOR AUTO-IRIS LENSES
1.
Fit the optics on the camera.
2.
Connect the wire to the Auto-Iris connector.
3.
Adjust the zoom
4.
Select the lens to MANUAL (see EXPOSURE menu) and the shutter to AUTO (see
EXPOSURE/E.SHUTTER menu)
5.
Adjust the focus.
6.
Restore the lens to DC
USING COMMANDS AND PRESETTINGS
Button menù
DS1092-347B
19
Publicité
Table des Matières
