Installation; Mechanical Fastening - elero Picolo XL Instructions De Montage

Installation

CAUTION
Damage to the device due to the connecting rod jamming.
• The linear path of the piston must be freely moveable at all times.
• The pivoting range of the device must be kept free.
CAUTION
Damage to the device due to loss of the support and holding function.
• Pay attention to static loads.
CAUTION
Damage to the device due to faulty electrical connection.
• F or devices with protection type IP 65, the ends of all cables or connectors
must be protected against the penetration of moisture. This measure must
be implemented immediately after removal of the device from the original
packaging.
The device was manufactured with the circuit diagram ordered by you. The
designation can be found in the sales documentation or the circuit diagram enc-
losed with the delivery.
In delivery condition (factory setting), the connecting rod is already slightly
extended. Please refer to the sales documents for the minimum and maximum
dimensions.
4.1

Mechanical fastening

CAUTION
Damage to the device due to torsional forces.
• No torsional forces may be allowed to act on the device.
CAUTION
Damage to the electrical leads due to crushing or a tensile load.
• A ll electrical leads have to be laid so that they are not exposed to any crus-
hing or tensile loads.
• Observe the bending radii of the cables (at least 50 mm).
Fasten the device only by the fastening elements provided for this purpose. The-
se are located at the end of the housing and on the piston rod. Another optional
fastening component is the swing fastening.
16