Télécharger Imprimer la page

User Notes; Configuration Options - YORKVILLE Legacy Série Manuel De L'utilisateur

Masquer les pouces Voir aussi pour Legacy Série:

Publicité

Les langues disponibles

Les langues disponibles

USER NOTES

For normal operation connect the PS210P just like an ordinary speaker, along with the Full-Range speakers
and set the Input Level switch to SPEAKER. If the audio source does not have a ground pin on the AC cord,
the Input Ground switch must be set to GROUND (GND). The PS210P may be plugged in before or after
the Full-Range speakers. Use the Left and Right Inputs when using a single PS210P in a stereo system. Use
either the Left or the Right inputs when using separate PS210P's for each side (or when used in a Mono
system). The PS210P does not alter the signal to the Full-Range speakers, and will not draw any power
from the host amplifier driving them. Please note that an external crossover is not necessary.
Note: The PS210P built-in stand mounting adapter can be used with Yorkville SW-Teletube
accessory to support our E160 cabinets. The support tube can be adusted up to it's full 5'4"
extension safely as long as the PS210P is not inclined more than 10°.
WARNING: Larger/heavier cabinets should not be used with the stand mount!

CONFIGURATION OPTIONS

The PS210P may be used in several different configurations. The minimum standard system is one PS210P
used with a pair of full range speakers. The PS210P accepts separate left and right signals and combines
them into one signal to drive the internal speakers.
When used in a setup where only one signal is provided to a speaker, such as a mono system (figure 2) or
stereo with more than one PS210P, use either the left or right input (figure 3).
ONE SUBWOOFER, WITH STEREO SYSTEM
PS210P
POWER
SUBWOOFER
AMPLIFIER
Left
Right
TWO SUBWOOFERS PER SYSTEM
Left
FULL–RANGE
SPEAKER
POWER
PS210P
AMPLIFIER
SUBWOOFER
FULL–RANGE
SPEAKERS
Left
Right
figure 1
Right
FULL–RANGE
SPEAKER
PS210P
SUBWOOFER
figure 3
ONE SUBWOOFER, WITH MONO SYSTEM
PS210P
POWER
SUBWOOFER
AMPLIFIER
Output
ONE SUBWOOFER USING A PROCESSOR
PROCESSOR
L
R
MID/
SUB
MID/
SUB
INPUT
HI
OUT
INPUT
HI
OUT
POWER
AMPLIFIER
R
AMP IN
L
2
FULL–RANGE
SPEAKER/s
figure 2
PS210P
SUBWOOFER
Left
FULL–RANGE
SPEAKERS
Right
AMP OUT
figure 4

Publicité

loading

Ce manuel est également adapté pour:

Legacy pulse ps210p