Whirlpool duet YGEW9200LQ0 Guide D'utilisation Et D'entretien page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Reverse the hinge and hinge bracket
1. Place the inner door, screwhead side up, on the work surface.
2. Remove the 4 screws that hold the hinge to the door.
3. Remove the 2 screws that hold the handle bracket to the
door.
4. Move hinge to the other side and reattach.
5. Move handle bracket to the other side and reattach.
6. Set the inner door assembly aside.
Reinstalling the door
1. Check for fingerprints on the glass. Clean if necessary.
2. Place the inner door assembly into the outer door assembly.
Align the hinge in the opening on the side. To fit correctly, the
inside door assembly edge is completely inside the outside
door assembly edge.
3. Reassemble the inner and outer door assemblies with the 6
screws.
4. Insert the new handle into the side opening of the door. Make
sure the handle seats all the way in, and the holes line up with
the holes in the door. Reattach with 2 screws.
5. Use a small flat-head screwdriver to remove hole plugs in the
door opening. Slide the head of the screwdriver under the
cap of each hole plug, being careful not to scratch the dryer
surface. Lift up. Remove the hole plugs in the door opening
and insert in the opposite side.
6. Insert a screw in the second opening from the top of the
hinge opening and partially tighten. Hang the door by placing
the top hinge keyhole over the second screwhead and tighten
the screw. By putting this screw in first, the door will hang in
place while you insert and tighten the remaining 4 screws.
Install new handle filler and hinge cover
1. Using the new handle filler provided in the reversing kit, hook
the top of the handle filler onto the loosened upper door trim.
Snap the joined pieces into place. You may need to use the
heel of your hand to firmly snap the pieces back into place.
2. Hook the bottom of the handle filler onto the lower door trim
and snap into place.
3. Repeat steps 1 and 2 to install the hinge cover on the
opposite side.
4. Close the door and check that it latches securely.
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Duet ygew9200lw0Duet ggw9200lq0Duet ggw9200lw0

Table des Matières