Télécharger Imprimer la page

Trilux 8841 LS Série Instructions De Montage page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
EN
For your safety
Read all instructions and mounting steps
carefully. Keep the instructions for maintenance
or disassembly work.
Explanation of the warning levels
Observe and follow the warnings.
Non-observance of the warnings may lead
to injuries or material damage!
WARNING! Indicates dangers which
can result in serious and/or fatal
injuries.
CAUTION! Indicates dangers which
can result in injuries or health hazards.
NOTICE. Indicates dangers which
can result in material damage or
malfunctions.
TIP. Indicates information containing
advice or a useful note.
Explanation of important symbols and
pictograms
Indicates professional personnel who
are trained and authorised to carry
out the electrical connection.
Indicates professional personnel who
are trained and authorised to carry
out the mounting.
Safety notes
WARNING! Risk of electric shock!
Never work on the luminaire with
voltage applied.
WARNING! Risk of electric shock!
The light source of this luminaire shall
only be replaced by the manufacturer
or a service technician authorised by
the manufacturer or a similar
qualified person. If the light source
malfunctions or fails, please contact
TRILUX.
4 | 32
8841 LS
WARNING! Observe the information in
the manufacturer's operating instruc-
tions
CAUTION! Risk of eye damage! Do not
stare into the active light source.
LED module: risk group 2. Position the
luminaire so that looking for a longer
period of time into the luminaire at
a distance closer than 0.4 m is not
expected.
NOTICE. Use suitable devices for
connecting the luminaire. A suitable
device is e.g. a cable junction box
with series terminals for cables with
cross-section X x 1,5
/ 2,5
/ and
rated voltage of 250/400V.
On customer request, connecting
cables with additional wires can be
used. Protect the unused wires from
contact on site.
NOTICE. Wear clean installation
gloves to prevent soiling.
Important information on electronic control
gear units (ECG)
A neutral conductor interruption in the three-
phase circuit leads to overvoltage damage
in the lighting system. Only open the neutral
conductor isolating terminal in de-energised
state, and close the neutral conductor isolating
terminal before switching on again. Do not
exceed the maximum permissible ambient
temperature t
of the luminaire.
a
Exceeding this limit reduces the service life
and in extreme cases there is a risk of premature
failure of the luminaire. Design connection
cables for the control inputs of dimmable
ECGs (1-10 V, DALI etc.) to be 230 V mains
voltage-proof (basic insulation).
10135819 | 200731 | © trilux.com
8841 LS
Important information on load effects.
The luminaire meets the requirements of
IEC 60598 and is designed for the exposure to
wind according to EN 1991 (Eurocode) with
basic velocity of up to 30 m/s (corresponds
to wind zone 4 in Germany) in terrain category 1.
A snow load (up to 1 kN/m²) and icing (up to
20 mm) at a mounting height according to the
mounting instructions are taken into account.
Impact loads and exposed locations such as
bridges, installation on buildings and in
stallation directly adjacent to railway tracks
are not taken into account.
Important information on the connecting cable.
Operate the luminaire only with an
undamaged outer cable. To avoid hazards,
a damaged outer cable of this luminaire
shall only be replaced by TRILUX, its service
partner or a comparably qualified person.
Important information on mounting the
luminaire
With LED outdoor luminaires with safety
class II, weather-induced static charges in the
luminaire housing may impair the function
and service life of the LED modules. TRILUX
recommends: Mount the luminaire in such a
way that there is a low-resistance electrical
connection from the luminaire housing to the
ground.
© trilux.com | 200731 | 10135819
EN
Intended use
Intended for outdoor use with an ambient
temperature of: ta 35 °C
Safety class: II
Protection rating: IP66
Disposal of waste electrical and electronic
equipment
Always collect and dispose of old
electrical and electronic equipment
separately at the end of its service life.
In case of doubt, seek information
about environmentally-compliant waste
disposal from your local district
authority or special waste disposal
companies. For important information
on the energy efficiency of TRILUX
luminaires and on maintaining and
disposing of luminaires, see the
Internet at:
www.trilux.com/eg245
Directive 2014/53/EU
Simplified EU Declaration of Conformity
according to the RED Directive if the luminai-
re is equipped with a control gear unit with
NFC interface or a radio component: TRILUX
hereby declares that the radio system type in
the following luminaire types complies with
Directive 2014/53/EU:
...
884
The full text of the EU Declaration of Confor-
mity is available on the internet at:
www.trilux.com/eu-conformity
5 | 32

Publicité

loading

Ce manuel est également adapté pour:

8841 ls