Unitekno 902 Manuel D'utilisation Et D'entretien page 18

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
MAINTENANCE
A certain amount of deposit will form
inside the heater according to how
much it is used and how hard the
water is.
HOW TO REMOVE DEPOSIT
FROM THE HEATER
Check that no accessory is connec-
ted to the steam generator. Unscrew
the metal cap on top of the heater
unit. Pour 1/2 a glass of white wine
vinegar into the empty heater and
screw on
DISPOSAL INSTRUCTIONS AND ENVIRONMETAL STANDARDS
The technical data and information given in this handbook are not binding. The manufacturer reserves the right to carry
out any necessary modifications without prior notice or replacement.
18
the cap. Make sure that there is
water in the cold water reservoir.
Switch on the heater until the correct
temperature has been reached.
Switch off the appliance and wait un-
til the internal pressure has subsided.
Unscrew the metal cap again, empty
the heater and rinse thoroughly with
clean water.
Close by screwing on the metal cap.
Do not empty the steam through the
iron or the nozzle.
Dispose of packaging and used filters in accordance with current standards. Follow the instruc-
tions for any material recycling (segregated collection) in your area. The symbol of a crossed out
basket on the device specifies that the product should be disposed of separately from domestic
waste at the end of its useful life.
This device complies with EU standards 2012/19/EU. The user is responsible for taking device
to an appropriate collection device to an appropriate collection point. Suitable segregated
collection for ensuing recycling, treatment and environmentally compatible disposal helps
prevent poten-tially negative effects on the environment and on health and favors recycling of
the product's materials. For more detailed information on available collection systems, consult
your local waste disposal service or the shop where the shop where the product was purchased.
HOW TO REMOVE DEPOSIT FROM
THE COLD WATER RESERVOIR
The cold water reservoir is controlled
by sensors, which may not work
properly when there is calcium
build-up. Therefore occasionally it is
necessary to pour 1/2 glass of white
vinegar in the cold water reservoir,
and then to spray a generous amount
of steam into the reservoir using the
steam nozzle. Following this opera-
tion, rinse well with water.

Publicité

Table des Matières
loading

Produits Connexes pour Unitekno 902

Ce manuel est également adapté pour:

902d902dw903903d903dw903 pro ... Afficher tout

Table des Matières