Table des Matières
Publicité
GENERAL INFORMATION
This item is available in the following variants. The
functions and technical data are the same. They
only differ in its design/in its colour.
8020314 CM3 000: black
8020314 UJT 000: dark grey
8020314 HUN 000: light grey
SCOPE OF DELIVERY
Wall clock (A), instruction manual
Required batteries: 1 x 1.5V battery (Size AA/LR6)
Batteries not included with purchase.
PARTS OVERVIEW
Wall clock (Fig. 2)
1. Dial plate
2. Clock hands (hours, minutes, seconds)
3. Wall mount
4. Battery compartment
5. Setting wheel
GETTING STARTED/POWER SUPPLY
1. Insert one battery (1.5V, AA/LR6) into battery
compartment (4).
2. Turn the setting wheel (5) until the desired time
is set.
MOUNTING/POSITIONING
NOTE!
Make sure you have mounted or placed the device
in a safe way. Otherwise the device may fall down
and heavy damages can occur for which the man-
ufacturer is not liable.
The wall clock can be mounted on walls with the
wall mount (3).
CLEANING AND MAINTENANCE
Before cleaning the device, disconnect it from the
power supply (remove batteries)!
Only use a dry cloth to clean the exterior of the de-
vice. To avoid damaging the electronics, do not use
any cleaning fluid.
Protect the device from dust and moisture. The
batteries should be removed from the unit if it has
not been used for a long time.
(Fig. 1)
DISPOSAL
Dispose of the packaging materials properly,
according to their type, such as paper or card-
board. Contact your local waste-disposal service
or environmental authority for information on the
proper disposal.
Do not dispose of electronic devices in the
household garbage!
As per Directive 2002/96/EC of the European Par-
liament on waste electrical and electronic equip-
ment and its adaptation into German law, used
electronic devices must be collected separately
and recycled in an environmentally friendly man-
ner.
The integrated battery must only be removed
for disposal. Opening the device housing can
damage the unit.
Drain the battery completely before disposal. Re-
move all the screws in the housing and open the
device housing. Remove the connections to the
battery and remove it. Cover the open contacts
with tape and package the battery in such a way
that it cannot shift in the packaging.
EC DECLARATION OF CONFORMITY
Bresser GmbH has issued a „Declaration of Con-
formity" in accordance with applicable guidelines
and corresponding standards. This can be viewed
any time upon request.
DE
GB
FR
IT
ES
5
Publicité
Table des Matières
