Bluetooth - Sharp Osaka Manuel D'utilisation

• Station name or frequency – e.g., BBC R4,
93.30MHz
• Signal
• Power status

Bluetooth

Enter Bluetooth mode by short pressing
until the radio displays <Bluetooth>.
Your radio will enter pairing mode. Ensure the
device you are trying to connect the radio to has
Bluetooth enabled.
NOTE: If necessary, refer to the instructions for your
device to add or set up Bluetooth.
Search the available Bluetooth device list for
'SHARP DR-P530' and select it to connect. Once
connected, the display will read <Connected>.
The Bluetooth connection should have a range
of up to 10m (line of sight). Walls or other objects
which obstruct the line of sight will reduce the
effective range.
Your device will remain paired with the radio
unless you decide to disconnect it or turn off a
device.
To disconnect from Bluetooth, long press
3 seconds to unpair your current device and
search for new devices.
Wirelessly stream music via
Bluetooth
In Bluetooth mode, you can wirelessly stream
audio through the radio's built-in speaker. Use the
controls on your paired Bluetooth device as well
as those on your radio. Controls available:
•
: Short press to play/pause
•
Short press for previous track. Long press
to fast rewind.
•
Short press for next track. Long press to
fast forward.
Volume can also be adjusted – either using your
radio and/or your connected device.
Alarm functionality
Set an alarm
NOTE: Check that the radio has the correct time and
date before you set an alarm.
1. Enter the menu options and select <System
Settings> and then <Alarm>.
The display will read <Alarm 1> and
2.
<Alarm 2>. Use
that you'd like to set.
3. Short press the
Alarm information and options available.
4. Use or
the list. Press the
change each setting and press the
to confirm.
The settings are:
• Alarm: On or Off
• Frequency: Daily, once, weekends or
weekdays
• Hour
• Min
• Source:
for
With BestTune™ on: Buzzer, radio
With BestTune™ off: Buzzer, DAB, FM
• Duration: 1, 5, 10, 15, 30, or 60 minutes
• Volume level: 0%-100%
5. Check that you have selected to turn the
Alarm <On> before you exit the Alarm menu.
6. When an alarm has been set, an alarm clock
symbol will be displayed in Standby mode.
Stop, snooze or switching the
alarm off
To stop the alarm, short press any button (except
/ /
off>. The alarm symbol will remain in the display
and will sound again at the same time the next
day unless it was set for <Once>. To snooze the
alarm, press
displayed. Once the countdown ends, the alarm
will sound again. You can terminate snooze by
pressing any button (except
). The display will read <Alarm off>. To switch off
the alarm, follow the steps for 'Set an alarm' and
or to highlight the alarm
button to display the
to highlight each alarm option in
button. Use
/ ). The display will read <Alarm
. A 10-minute countdown will be
/
EN
or to
button
/ /