Fault Diagnosis - Truvox Multiwash II 340/PUMP Battery Manuel D'utilisation

FAULT DIAGNOSIS

The following simple checks may be performed by the operator. If the machine is still not working, please contact your local Service Agent:
Trouble
Machine fails to start – no
power
Machine fails to pick up water
from the floor
Drum not rotating
Drum is rotating, but brushes
are not
Brushes not rotating
Machine fails to spray solution
onto the floor
* If the fuse blows several times, the machine should be checked by an authorised Service Agent.
4
Display Reason

Battery terminal is not connected

Mains switch on battery is in the off
position

Motor overload protector has
No LED Display tripped

Transport wheels not raising off the
ground when handle lowered

Transport working lever is in
bottom position

Incorrectly fitted / damaged
recovery tank
N/A

Worn brushes

Drum not rotating

Debris around drum or base of
N/A
machine
N/A 
Debris around brushes

Battery low voltage
LED flashes in RED

Motor overheated

Faulty pump

Incorrectly fitted / damaged
N/A
electrical cable

No solution in solution tank

Blocked jet

Blocked inline filter

Blocked filter or faulty valve in
solution tank
Remedy

Connect battery terminal

Switch to on position

Wait for 20 minutes to allow the motor
temperature to reach room temperature. Then
try again.

Check for debris and clean machine.

Change to operating position (see pictorial guide)

Refit or replace recovery tank

Check brush pressure, if needed replace brushes

See below

Clean drum and base of the machine

Clean or replace brushes

Charge the battery for 5 1/2 hours and then try
again.

Wait 20 minutes and restart

Can you hear the pump operating? If yes, see
below.
If no:
Check electrical cable is fitted correctly, see
below.

Refit / replace electrical cable - this should be on
the right hand side of the machine from the
operator's position.

Fill solution tank

Clean jet

Clean inline filter

Clean / replace filter or valve
10-18