Cleaning Agents; Transporting The Machine - Truvox Multiwash II 340/PUMP Battery Manuel D'utilisation

14. CAUTION - If it is suspected that there is hazardous dust or
flammable/corrosive material, stop cleaning the area immediately
and consult your superior.
15. DO NOT use to clean up any burning or lighted materials such as
cigarettes, matches, ashes or other combustible objects.
16. Only use the machine on firm level surfaces. DO NOT use on a
gradient or slope of more than 2%.
17. DO NOT use on rough uneven surfaces e.g. industrial or coarse
concrete surfaces.
18. DO NOT use outdoors e.g. on patios, decks or rough surfaces.
19. CAUTION - This machine is for dry indoor use only and should
not be used or stored outdoors in wet conditions.
20. Take care when using a machine near the top of stairs to avoid
overbalancing.
21. DO NOT cover the machine when in use.
22. DO NOT run the machine dry, as this could damage the floor
surface or the machine itself.
23. DO NOT leave machine running unattended.
24. Keep hair, loose clothing, hands, feet and all other parts of the
body away from openings and moving parts.
25. DO NOT put any object into openings. DO NOT use with any
opening blocked; keep free of dust, debris and anything that may
reduce airflow.
26. DO NOT use volatile
diesel/petrol/IPA/trichloromethane) nor any corrosive, toxic or
highly irritant substances to wash floors, even if diluted. In the
event of accidental contact with any such substances(e.g. due to
spills) follow the decontamination procedures in force at the user
site.If in any doubt about the condition of the machine, contact
Truvox or the dealer/agent who supplied the machine.
27. WARNING DO NOT fill the machine with water hotter than
40ºC.
USE ON ESCALATORS
28. Ensure the machine is positioned at the bottom of the escalator
with the escalator moving towards the operator.
29. DO NOT operate the machine with a damaged charger power
cord or plug, or after the machine malfunctions or is damaged in
any way. Contact an authorised Service Agent for repair or
adjustment.
30. The machine must be kept clean and in good condition with
regular inspections of the charger power cord and plug for signs of
any damage. If any parts are damaged they shall only be replaced by
an approved part by the manufacturer, its service agent or a similar
qualified person in order to avoid a hazard.
31. Only replace the charger power cord with the type specified in the
instruction manual.
32. When unplugging, pull the plug, not the charger power cord.
33. WARNING: Keep the charger power cord clear of moving parts.
34. DO NOT kink or twist the charger power cord and keep cord
away from heated surfaces.
35. DO NOT operate switches or touch the mains plug with wet
hands as this may cause electric shock.
36. DO NOT pull or carry by the charger power cord. DO NOT
use cord as a handle, close door on cord or pull cord around sharp
edges or corners.
37. Unless charging, the plug of the charger power cord must be
removed from the socket-outlet when not in use and before
commencing cleaning of the machine or undertaking maintenance
operations.
SAFE DISPOSAL OF BATTERIES

The batteries must be neutralised through an approved secondary
treatment facility prior to disposal as waste.
2
or combustible solvents

The battery can be recycled at an authorised facility, through a
licensed waste carrier.

CLEANING AGENTS

1. When using cleaning and care agents, the manufacturer's danger
warnings must be followed and protective goggles and clothing
must be worn.
2. Only use low-foaming, non-combustible cleaning agents which DO
NOT contain generally health-hazardous substances.
3. Please ensure that after each use any chemical residue is rinsed out
with clean water.
BRUSH IDENTIFICATION
Red, Blue, White and Yellow brush buttons are packed with the
machine. Simply plug the buttons into the hole in the brush as shown.
Clear identification,
contamination.

TRANSPORTING THE MACHINE


Take extreme care when moving the machine up or down steps or
stairs.

Incorrect lifting techniques may result in personal injury. We advise
that the manual handling regulations are followed. Carefully wrap
(e.g.
the charger power cord and store in dry indoor location.

DO NOT expose the machine to rain or moisture.

When transporting the machine ensure that all components, tanks
and removable parts are securely fastened, and that the charger
power cord and plug are not trailing.

Do not lift or transport the machine whilst containing liquid as this
will add considerably to the weight.

When transporting the machine the handle should be locked in the
upright position.
STORAGE

Always switch off the machine after use.

Store the machine in a dry indoor area only.

Always switch off, empty, wipe down and dry the machine after
use.

Both the solution and recovery tanks should be emptied and
flushed out with clean water to ensure the seals and pumps are
free from any cleaning detergents.
MAINTENANCE
WARNING - Before undertaking maintenance
operations or adjustments switch off machine and
unplug from the electricity supply.
IMPORTANT – All other servicing and repairs should only be
performed by a Truvox engineer or Authorised Service Agent.
IMPORTANT – Should the machine fail to operate please refer to the
fault diagnosis section in the back of this instruction manual. If the
problem / remedy is not listed please contact Truvox Customer Service
Department for rapid attention.
The machine requires minimum maintenance apart from the following
checks by the operator prior to use:

Body of the machine - Clean with a damp cloth.

Charger power cord - Regularly inspect sheath, plug and cord
anchorage for damage or loose connection. Only replace the
charger power cord with the type specified in these instructions.

Brushes - For maximum life, wash the brushes regularly. Ensure
machine is in Transport mode when not in use. Store additional
brushes in a vertical position to avoid bending of bristles. Check
for permanent bending of bristles in a particular direction. This may
occur if the machine is operated for several days without removing
the brushes, which is not recommended. If this occurs, reverse the
brush so that the bent bristles are automatically straightened.

Wiper Blade - After years of use the wiper blade may wear. If this
occurs the water collection performance will decrease. It should
be replaced by an authorised service agent.
by colour coding, helps prevent cross
10-18