ayerbe 587300 Mode D'emploi page 24

6. After wet vacuuming, turn the machine off and remove plug from power supply. To prevent the risk of
possible mildew, empty the container, clean and dry the inside and outside of the container, and
remove the foam filter and allow to air dry before storage.
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the nozzle completely in
the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float
valve that stops the suction action when the container reaches its maximum capacity. You will notice an
increase in motor speed. When this happens, turn off the machine, disconnect from power supply, and
empty the liquid into a suitable receptacle or drain. To continue vacuuming, refit the power head to the
container. After wet vacuuming, turn the machine off and remove plug from power supply. To prevent
the risk of possible mildew, empty the container, clean and dry the inside and outside of the container,
and remove the foam filter and allow to air dry before storage.
REMEMBER!
The foam filter must be removed after wet vacuuming, and a cartridge filter must be
installed before dry vacuuming again.
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Make sure the container is empty before using as a blower.
3. Remove the noise diffuser from the blower port. (fig. 2)
4. Remove hose from the vacuum port and insert the locking end of the hose into the blowing port on
the power head and lock into position. (fig. 3)
5. Fit the desired extension wand and or nozzle to the free end of the vacuum hose. (fig. 4)
6. Ensure the power switch is turned off and plug in the power supply. (fig. 5)
7. Before turning on the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch
to the 'I' ON position or use the vac with switch set to remote control setting and the remote control.
(fig. 6)
OPERATION
24