Frigidaire CPLCF489DC4 Manuel D'utilisation Et D'entretien page 20

(Continued)
To Remove and Replace Right Oven Door
1. Open the door to the fully opened position.
2. Pull up tile lock located on both hinge supports and engage it in the hinge
levers. You may have to apply a little downward pressure on the door to pull the
locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to
disengage the hinge supports. Keep pulling the bottom of the door toward you
while rotating the top of the door toward the range to completely disengage the
hinge levers.
4. To replace the door, reverse the door removal steps. Make sure tile hinge sup-
ports are fully engaged before unlocking the hinge levers.
Tile door is heavy. After removing door, lay it flat on the floor with
its inside facing down.
m Lock engaged
for door removal
I
B
Push down with finger Right Glide
Fig. 1
To Remove and Replace Storage Drawer
To Remove Storage Drawer:
1. Open the drawer to the fully opened position.
2. Locate the glide lever on each side of drawer; pull up on the left glide lever and
push down on the right glide lever (see figure I).
3. Pull the drawer away from the range.
To Replace Storage Drawer:
1. Pull the bearing glides to the front of the range (see figure 2).
2. Align tile drawer glides with tile slots on the bearing glides.
3. Push the drawer into the range until the glides levers "click" (approx. 2 in.). Pull
the drawer open again to seat it into position.
4. tf you do not hear the glide levers "click" or if the drawer does not feel
seated, remove it and repeat steps ! through 3. Doing so will minimize
damage to the bearing glides. Do not try to force the drawer into place.
Fig. 2
2O