Husqvarna CRT900L Manuel De L'opérateur page 16

SERVICE AND ADJUSTMENTS
NEW TINE
SHARP EDGE
COUNTER
TINE
ROTATION
SHEAR PIN
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 26)
The throttle control has been preset at the factory and
ad just ment should not be necessary. If adjustment is
necessary, proceed as follows:
• With engine not running, remove air cleaner cover and
cartridge (See "AIR CLEANER" in the Maintenance
section of this manual).
• Move remote throttle control to "FAST" position.
WORN TINE
Fig.23
SHARP
EDGE
SHEAR PIN
TINE
3-1/2" MAX
(9 CM)
HAIRPIN CLIP
SHARP EDGES
SHARP
EDGES
tine_13
Fig. 25
• If throttle lever on engine touches high speed stop, no
further adjustment is necessary. If throttle lever does
not touch high speed stop, continue with adjustment
procedure.
• Loosen cable clamp screw.
• Pull cable backward until throttle lever contacts the
high speed stop, and hold in this position.
• Tighten cable clamp screw securely.
• Reinstall air cleaner cover and cartridge.
16
TRANS MIS SION
TINE
Fig. 24
HAIRPIN CLIP
SHARP EDGE
tine_3