Assembly Instructions / Instructions For Use And Safety Tips - Amazonas KOALA Notice De Montage Et D'emploi

GB:
Important – keep for
future reference!
I. Assembly instructions
A Fold out the side parts of the stand (with the rubber feet facing downward!) and set
up in accordance with the illustrations.
B Hang the baby hammock (with wooden expansion struts) into the hook in the eye bolt.
C If you want to make absolutely sure that the hammock cannot overturn, you can install
the safety belt under the hammock. This is particularly important if there are other
children or a dog in your home, which might to rock the baby.
D Install the safety harness system under the hammock in accordance with the illustrations.
Make sure that the two horizontal belts which grab around the ground struts are firmly
tightened. The belt directly under the hammock can be adapted to the height of the
hammock and should be slightly taut in order to limit the rocking motion.
II. Instructions for use and safety tips
Instructions for use
E Adjusting the Depth of the Hammock
Open press-stud on the corner of the baby hammock and uncover the wooden rod. Push
back the hammock material, so that the knot becomes visible.
Loosen knot and pull the cord outwards through the slit in the wooden rod, until the desired
gathering is achieved.
Tighten the knot again and close press-stud.
Repeat process on all four corners.
Result: hammock hangs lower.
- > If a flatter surface for lying down is desired on the hammock, the cord must be
shifted inwards after loosening of the knot.
F Adjustability of the suspension height of the hammock
There is a metal triangle to adjust the suspension height of the Koala on each of the four long
suspension ropes.
Arrange the metal triangles so that the long suspension ropes run in a straight line through
the triangles. Now push all four metal triangles up at the same time to move the hammock
lower, or move them down to increase the hammock's height from the ground.
Once the hammock is at the right height, arrange the four metal triangles so that they are at
an angle to the suspension ropes. The ropes cannot slip now and the height can no longer be
adjusted — test this by gently pushing in the middle of the hammock.
Do not make an adjustment while your child is in the hammock and only put them back in
once you are sure that the metal triangles are set correctly.
5