Create Cyclone Force Manuel D'utilisation page 9

LOADING THE VACU UM
When the vacuum cleaner is charging, the display shows "GEAR" and the battery charge status.
1. Place the vacuum cleaner near a power source in a suitable position to prevent falls and
damage.
2. Connect the machine to the charger and connect it to the power source.
3. When the power indicator lights up, charging will start.
4. The color of the power indicator will change according to the remaining power. You can
check the charge from the digital display.
5. When the vacuum cleaner is fully charged, the power indicator will turn off.
BAT TE RY STATU S I NDI CATO R
The color of the power indicator will change ac-
cording to the remaining battery percentage:
• Upon reaching the 70% battery level, the
color of the indicator will change from
blue to pink.
• When it reaches 40% of the battery it
changes to red.
• When the battery reaches 11%, the screen
flashes until the device turns off.
When charging, the battery indicator light will turn on and the control panel will indicate
the percentage of battery charged.
Charging time is approximately 2-3 hours.
Note: If the vacuum cleaner has no battery, pressing the power button will cause the red
light to flash.
WA LL HOOK MOU NT
1. Choose a spot on the wall where you want
to mount the wall hook. Make sure it is tall
enough to support the vacuum consider-
ing its length.
2. With the help of a level, mark the points
where the holes for the screws and an-
chors will be drilled.
3. Place the wall hook over the drilled holes
and align the mounting holes with them.
Use screws to fix the wall hook in place.
4. Be sure to locate the wall hook near a
power source in order to charge.
5. For safety, check that the hitch is secured to the wall firmly and level. If necessary,
make adjustments to achieve the desired position.
6. Once securely anchored, place the vacuum on the hitch and check if the load works
properly.
100
100
E NGLI SH
9