Winner Sat V3AA Manuel D'utilisation page 21

Connecting Receiver to Remote TV through VCR
This setup enables you to record transmitted audio and video on your remote VCR and also enjoy the
picture and sound on a remote TV at the same time.
1. Connect one set of audio/video (A/V) cables to the A/V output jacks of the receiver (X300A or X301A)
and to the A/V input jacks on your VCR. Be sure the yellow, red and white plugs match the yellow, red and
white jacks on both the system receiver and the VCR. If the VCR has only a single jack for audio input,
connect the white plug to it.
2. If your TV has A/V input jacks, connect another set of A/V cables to the TV's A/V input jacks and to the
A/V output jacks on your VCR.
3. If your TV does not have any A/V input jack, in this case, please connect a 75 ohm coaxial cable from
the TV's antenna in (or VHF/UHF in) to VCR's modulator output.
this feature is optional4. Plug one end of the power adapter into the back of the receiver and the other end
into any 230 volt (or 120 volt) wall outlet. Use only the adapter provided.
make sure the ON/OFF switch is in the 「OFF」position before connection
5. Locate and orient the receiver to best video and sound quality.
AUDIO
CHANNEL
ON OFF
1 2 3 4
L R VIDEO DC 9V
UHF ANT