Chamberlain K41-0216-000 Manuel D'instructions

INTRODUCTION
The K41-0216-000 Front Panel with Display Kit
is a replacement for the Smart Video Intercom M
(Model CAPXM).
K41-0216-000 Carton Inventory: Fully assembled
CAPXM door with LCD display and touchscreen
assembly, installation instructions.
INSTALLATION INSTRUCTIONS
1. Disconnect power to the CAPXM.
2. Disconnect the door retention tether (Figure A).
3. Unplug all power connections and antenna coaxial cables.
4. Unscrew the four screws at the bottom hinge that hold the faceplate
to the back housing (Figure A).
5. Remove the door and place it on a safe workspace.
6. Label and disconnect all wired components.
7. Remove the Cover Bracket (Figure A).
8. Use a 1/4" nut driver to remove the Control Board (Figure B).
9. Use plastic tweezers to remove the antenna connector (Figure B).
Control Board (Front)
Microphone
Speaker
Antenna Connector
www.SimpleGateOpener.com | (888) 378-1618 | Sales@SimpleGateOpener.com
Figure A
Figure B
Ethernet
Door Board
USB (Camera)
Power
Postal Lock
FRONT PANEL WITH DISPLAY KIT, CAPXM
To prevent possible SERIOUS INJURY or DEATH, disconnect
electric power to operator BEFORE installing.
ALL installations and electrical connections MUST be made by
a qualified individual.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer
or birth defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov.
Cover Bracket
Control Board 1/4" nuts
Control Board Antenna Connector
Bracket Screws
K41-0216-000
Hinge Screws
Tether Connection Point
Control Board
Bracket Screws