To Clean Hood Surface; Replace Lights - Dcs Es30 Guide D'utilisation Et D'entretien

USE AND CARE
TO CLEAN HOOD SURFACE
n For genera[ care, wipe the outside of the stainless steel with sudsy water or household cleaners
such as Fantastk o or Formula 409 o, rinse we[[ and dry with dean soft cloth to avoid water
marks.
m Wipe and dry brushed stMn[ess steel in the same direction as the grain.
m Do not use abrasive products.
m To remove finger prints and give added shine use spray cHeaners such as StainHess Stee[ Magic °
and Shimmer °
LIGHTS
CAUTION,°
Before repladng the lamps, switch power off at service panel and lock service
panel disconnecting means to prevent power from being switched on
accidentally.
NOTE: Turn off the lights and fan. Allow the lights to cool before handling, tf new lights do not
operate, be sure lights are inserted correctly before calling service.
REPLACE LIGHTS
m Remove the damaged Hight (twist counter c[ockwise)and repHace with a new 120 VoHt,50 Watt
(maximum) 50 ° halogen light made for a GUIO base.
z_ WARNING:
Halogen lamps are constructed of a glass bulb with a pressurized internal
filament tube that operates at high temperatures and could unexpectedly
shatter Should the outer bulb break, particles of extrem!!y hot glass could be
discharged into the fixture enclosure and/or surrounding environment,
thereby creating a risk of personal injury or fire. When replacing the bulb, let
the bulb cool, and assure that power to the light has been turned off. Never
allow the hot bulb to come into contact with water DO NOT TOUCH the Light
Bulb when in use. They may be hot enough to cause injury.
INFRARED LAMP AND PANEL KIT:
Optional infrared lamp and panel kit can be ordered separately and mounted into your vent hood:
Models available are JR30, 1R36 and 1R48.
z_ WARNING
To avoid any electrical shock the installation of the IR lamp should be done by
a qualified electrician and before starting the installation of the hood.