Creative WebCam Vista Plus Manuel D'instructions page 4

CLE_WCam Vista Plus QS.book Page 2 Monday, December 20, 2004 12:35 PM
Getting Started
1
1
Installing Your Creative WebCam
Do not connect your Creative WebCam to your computer before installing the drivers. If
you accidentally begin installation with your Creative WebCam connected and the Add
New Hardware Wizard or Found New Hardware Wizard dialog box appears, click
the Cancel button.
1. Insert the Installation CD into your CD-ROM drive. If it does not run automatically,
click Start → Run and type d:\setup.exe (replace d:\ with the drive letter of your
CD-ROM drive).
2. Select the region you are in and then click the Next button.
3. Select a language and then click the Next button.
4. Click the options for installing drivers and applications, and then click the Install
button.
5. Place your Creative WebCam on top of your computer monitor or other flat surface.
For LCD flat panel monitors or notebook computers, use the integrated hinged lever
to balance the Creative WebCam (see Figure 2).
2
Figure 2