Whirlpool 24-Inch - Built-In Dishwasher (Color: Silver) Energy Instructions D’installation page 16

Connect to Drain
Green clamp
Black drain hose Drain hose
connector --
Drain hose stop
Stop
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of
the drain hose. Push the new drain hose into the black drain
hose connector up to the drain hose stop.
Using pliers, squeeze open the small green drain hose clamp
and slide onto connector between stops.
Hose clamp final position
Black drain hose
connector --
Green clamp
Drain hose
Drain hose stop
Stop
Once connected, remove towel.
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/drain under FAQ tab.
Make DirectWire Electrical
Connection
NOTE: If the power supply cord was connected earlier
proceed to "Secure Dishwasher in Cabinet Opening" section.
Option B, Direct Wire:
Route cable so that it does not touch dishwasher motor or
lower part of dishwasher tub. Pull cable through cable clamp in
terminal box.
Select UL listed or CSA approved twist-on wire connectors
(not included) rated to connect your household wiring to 16-gauge
dishwasher wiring.
16