Camera Installation - Beeper RWEC110X-N Manuel D'installation

6. CAMERA INSTALLATION

POSITION DE LA CAMERA
We recommend that you set the position of the camera with the user of the vehicule depending on the desired monitor. Conveniently the camera is positioned
at the rear of the vehicle in the center and as high as possible while avoiding to exceed the actual height of the vehicle. The orientation of the camer must be
connected after the system to control the optimal viewing angle through the screen.
FIXATION DE LA CAMÉRA
• Loosen the screws to remove the power block bracket camera.
• Attach the bracket to the location defined.
• Drill a hole to pass the cable. The cable gland must be sufficiently compressed to ensure a good seal. The cable must not be stretched and if possible, it
should be a gutter to prevent the ingress of water by capillarity.
• Screw the camera to the bracket using the center screw.
• Set the desired optimal viewing angle and firmly screw the 4 screws provided in the kit rotation.
NOTES
To avoid oxidation and corrosion of the body, we recommend that you apply a rust paint for
metal body at the drill holes. To ensure a perfect seal, we recommend that you fill the holes
with a silicone gasket.
Bracket
Camera
box
5,5 cm
Rotation screw
Central screw
21
5,5 cm
4,5 cm
5 cm
2,5 cm