Instructions For Use - RM SPLT-780-21 E Notice D'installation Et D'emploi

6

INSTRUCTIONS FOR USE

NSTRUCTION FOR USE
Attention! Before the fi rst use of the device you must remove protection foil from all surfaces and wash the
device with moist cleaning cloth dipped in the water with detergent. Than dry it with cloth.
The fi rst switching on device must be performed in a well ventilated room. The "burning of plates" (turn on full
power) takes about 30 minutes. After these 30 minutes the device is ready for operation.
Turn the knob (A) and adjust required performance. Pilot lamp (B) will light. Pilot lamp (B) lights when the
device is connected to the electricity and switched on. Switch the device off by turning the knob (A) into
position „0".
MAINTENANCE
We recommend to have the device checked once a year by the professional service. Only qualifi ed or
competent persons can do interventions in the product. Comments and recommendation. Use the device
only under supervision.
B
A
Control of the elecrtic oven
Control of the electic oven (STATIC)
You can choose to switch the control knob into select position for top and bottom heaters at the
same time (position 1), or just the bottom heater (position 3) or upper heater (position 2). This is
indicated by green LED. Set the control knob into desired temperature. Working heater is indicated
by orange LED, when light goes off , the oven is preheated to the requested temperature. Turn off
the oven by turning both knobs to „0".
Control of the convection oven
Turn the control knob to the right, will turn on the fan. This is signalized with a green LED. After
that, set the control knob into desired temperature. Working of the heater is indicated by orange
LED, when light goes off , the oven is preheated to the desired temperature. Turn off the oven by
turning left into the "0".
You can also clean the area beneath the hotplates. There is space around the hotplates, which ena-
bles residue to be swept into the equipment. After they have cooled the hotplates are lifted and pla-
ced on the upper panel to enable access to the bath in which the hotplates are situated. The residue
is then swept out through the opening, which leads into the drawer. This drawer is then removed,
the residue emptied and the drawer returned to its place. The drawer is slides out from the front of
the equipment (the face)"