LENCO HPB-730 Mode D'emploi page 7

Operating Instructions and LED Indicator information.
To
Power on
Power off
Pairing
Adjust the volume
Play/pause
Next track
Previous track
Answer a call
End a call
Reject a call
Redial previous number
Incoming call
Charging
Charging completed
Warning!
•
Do not insert plug into electric sockets.
•
Listening to headphones at high volume levels-particularly, over extended periods of time-may damage your
hearing.
•
If you have a pacemaker or other electronic medical devices, you should ask your doctor before using the product.
•
Do not use headphone while driving or cycling.
Pairing
1. Ensure that your phone or Bluetooth device is switched on.
2. To pair the headset that has not been previously paired with a device, please switch on the headset. Then, the
headset enters the pairing mode, and the blue & red indicator light starts to flash alternately quickly. To pair the
headset that has been previously paired with another device, please make sure that the other device is switched
off.
3. Activate the Bluetooth on your phone or Bluetooth device, and set it to searching Bluetooth device.
4. Select "Lenco HPB-730" from the list of found devices on your phone or Bluetooth devices.
5. When Bluetooth is paired successfully, there will be prompt tone and the blue light turns to lighting continuously.
The headset that has been previously paired with a device will automatically connect with the device if the device is
powered on and within connecting range. If not, the headset will enter standby mode and the blue light will keep
lighting. Under Bluetooth searching mode or re-connecting mode, the headset will switch off the Bluetooth
automatically after 5 minutes.
Do this
Press and hold MFB for 2~3 seconds; Prompt tone: Power on; LED: Blue light.
Press and hold MFB for 3~4 seconds; Prompt tone: Power off; LED: Red light turn off.
Press and hold MFB for 4 seconds; Prompt tone: Pairing; LED: Blue LED & Red LED
flash alternatively. (NOTE: when ANC is active then the color will be green/blue) Once
the headphone is connected with a device, there will be a prompt tone: Connected.
Short press +/- button. When the max volume is reached the headphones will indicate
with a prompt tone: Maximum. When the minimum volume is reached there will be
a beep sound.
Press MFB once to pause. Press again to resume.
Long press + button
Long press – button
Quick Press MFB
Quick Press MFB
Press and hold MFB for 1.5 seconds
Quickly press MFB twice
Blue LED
Red LED light solid during charging
LED light will turn off
7