Safety Measures - Carmen ADVANCED TRAVEL 2000 Mode D'emploi

4 • ENGLISH
> SAFETY MEASURES
• DANGER! Never allow the device to get wet (in
the rain, at a tap, near a bathtub, etc.) as you
might experience an electrical shock.
• Never use this device near water, in or near a bathtub, a
sink or another basin containing water.
• Never handle the device with wet or damp hands.
• Never submerse the device in water or another liquid.
• Immediately unplug the device if it has become wet or
damp.
• Never place the device on a damp surface or a damp
cloth when the plug is in the wall socket.
• To ensure additional protection have installed in your
bathroom a residual current device (RCD) with a nominal
trip current no higher than 30mA. Ask your electrical
fitter for advice.
• Unplug the device after use when using it in a bathroom.
The presence of water nearby is a hazard, even when
the device is switched off.
• Check the product immediately after unpacking for any
damage caused during transport or for completeness.
If the packaging is not complete or the product is
damaged, please contact the retailer a.s.a.p.
• Caution! Maintain a distance of at least 15 centimetres
between the hairdryer and the hair. Hair can become
brittle when excessively heated.
• This device is not intended to be used by persons,
including children, whose physical, sensory or mental
capacity is impaired, or who lack the necessary
experience or knowledge, even when a person
responsible for their safety supervises them and gives
them clear instructions for the use of the device.
• Children should not have access to the device, nor
should they play with it.
• Packaging material, including plastic bags, must be
stored out of the reach of children.
• You must use the device only for its intended purpose to
prevent hazardous situations.
• Make sure that the air intake and the blower nozzle are
completely clear when the device is plugged in. This
device is equipped with overheating protection: it will
switch off automatically when the airflow is impeded
(e.g. when the air intake or blower nozzle are blocked).
• If the device deactivates itself during use, set the switch
to position "0" and wait approximately five minutes
before switching it back on.
• The mains voltage must match the voltage specified on
the product.