Chamberlain LSIAC Guide D'utilisation

Overview
The Intercom has up to a 1000' range and allows
multiple simultaneous conversations, using a
900 Mhz secure digital radio link. The intercoms form
an exclusive network and respond only to other
intercoms in the network.
Carton Inventory
Intercom (2 in Model LSISC)
Operation & Features
Channel Lights
Talk Button
Monitor Button
Channel
Select
Button
AC Adapter
Learn Button
On/Off: To turn intercom ON, press Talk button.To
turn intercom OFF, hold down the Volume DOWN
button for 5 seconds.
Talk Button: To talk, hold down
the Talk button. All intercoms in
the network that are on the same
channel will receive the signal.
Release the Talk button when
done talking and within 10-15
seconds press and hold the Talk
button of a different intercom to make a secure
channel between the two. Once the channel is made
the other intercoms in the network cannot hear the
conversation.
Volume: Pressing the Volume DOWN button will
lower the volume and pressing the Volume UP button
will increase the volume.
Rubber Pads
(2 in Model LSISC)
Power Light
Active Light
Speaker
Volume DOWN
Button
Volume UP
Button
Dipswitch #1
Dipswitch #2
®
Wireless Portable Intercom - Extreme Range
Channel Select Button: Press the
Channel Select button to set
intercom to one of four secure
channels or the paging channel.
The default channel for the
intercom is the paging channel
where all four channel lights are lit.
An intercom on a channel can only hear an intercom
on the same channel or on the paging channel.
Battery: The AA Alkaline batteries (not provided) will
last up to a year depending on use (Lithium batteries
recommended for colder
environments). When batteries are
low intercom will emit two beeps
every ten minutes.
An AC Adapter (not provided) can
also be used to power the intercom.
In this case, both the power and
channel lights will remain on.
Conference Mode: Conference Mode allows multiple
intercoms to participate in a conversation compared
to Normal Mode in which only two intercoms can
communicate. All intercoms must be set to the same
channel or the paging channel to be in
Conference Mode. To put intercom in
Conference Mode set Dipswitch #2 to UP
position.
Monitor Mode: Monitor Mode is
used to monitor the noise in a
specific room. Place the intercom in
the room that is to be monitored
and press the Monitor button until a
tone is heard. The Active Light will
be lit while the intercom is in
Monitor Mode. Any other networked intercom can
listen to that room. If a specific channel is selected for
Monitor Mode then only other intercoms on that
channel or on the paging channel can listen. Press
the Monitor button again to exit Monitor Mode. A tone
will be heard indicating Monitor Mode is no longer
active.
Voice Activation Mode (VOX): Voice Activation
Mode (VOX) allows a call to be answered without
pressing the Talk button. Once a call is heard on an
intercom which has been set to VOX, a response can
be given by speaking loudly into the intercom. There
will be a slight delay when VOX is first activated by a
voice, but will continue to transmit audio until
the speaking stops. To put intercom into
VOX, place Dipswitch #1 to the UP position.
1
Model LSIAC & LSISC
OPTIONAL
1
2
1 2