Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
INSTALL AND FLUSH FILTER CARTRIDGE
Q.
Lift handle of the build-in shut off (QC Valve) on the
Head.
R.
Hold Head firmly with one hand.
S.
Align cartridge lug with label on filter Head.
T.
Insert filter Cartridge – Push upwards.
U.
Turn it to the right – About 1⁄4 turn – Until rotation stops.
V.
Open Side Valve of Angle Stop Adaptor and check for
leaks up to Inlet Elbow Fitting.
W.
Open Filtered Water Faucet.
X.
Lower the QC Valve Handle to flush water to the sink.
NOTE: Flush new filter cartridges for at least 3 minutes
to remove air and any loose carbon. At first the water
may appear cloudy due to trapped air in the filter and
tubing. If water continues to be cloudy for more that one
week, please contact Everpure Technical Services for
assistance.
Y.
Remove plastic wrapper and pull Tab from back of
Everpure Filter Timer. The LED and buzzer will cycle 3
times to confirm the start. It is programmed to flash/
sound again in 11 months. Remove adhesive backing and
mount Timer in a convenient location under the sink.
H-1200 INSTRUCTIONS
Tools Needed For Installation
•
Phillips Screwdriver
•
Wrench
•
Utility Knife
•
Measuring Tape
•
Pencil
1.
OPEN CARTON & INSPECT PARTS
Installation Parts
Key
Description
1
QL Twin Series Filter Head
2
Filter Cartridges (Set of 2)
3
2 Locking Washers
4
2 Screws
5
Angle Stop Valve Adaptor
6
Tubing, 1/4" poly
7
Elbow Fitting Pack Restrictor
8
Teflon
Tape
®
9
Faucet Connector
10
Everpure Filter Timer
11
Shut Off Valve,
3/8" John Guest x 3/8" FPT
12
Coupler, 3/8" FPT Stainless
6
V
y
1
1
Part No.
EV9272-25
EV9282-01
EV3062-04
EV3061-96
EV3121-20
A0860119
EV3081-68
EV3121-19
EV3121-35
EV9075-70
EV3098-60
EV3123-50
Q
S
Label
Lug
R
T
w
www.everpure.com
WATER FILTER MONITOR
4
3
7
2
6
10
9
U
X
5
8
11
12
• 5 •
Publicité
Table des Matières
