ADB SVOBODA Manuel D'utilisation page 6

SVOBODA
Advice before Use
• Read carefully these instructions.
• As soon as the equipment is delivered, open packings and
inspect the equipment carefully.
If you notice any damage, contact immediately the transport
company and register your complaint in due form with
mention of the defects. Be sure that this equipment left our
factory in perfect condition.
• Check if the received equipment is consistent with the
delivery notice and if this delivery notice is consistent with
your order. If it is not, contact immediately your supplier.
General Remarks
This luminaire is a lighting equipment designed for professional
use only in theatres and indoor television or movie studios.
Designed and built in accordance with EN 60950 safety
regulations, it must imperatively be connected to earth by
means of its earth wire. It also complies with the CEI safety
regulations (598-1/598-2-17 publications).
To prevent any electrical shock, there is no need to open this
equipment when functioning.
Nevertheless:
• Lamp must be changed if damaged or distorted by heat.
If internal access is needed for control, service or repair
purposes, always refer to qualified personnel.
In all events, always unplug the power supply cable before
opening,
LETHAL VOLTAGE PRESENT INSIDE
It is the user's responsibility to use the luminaire for its
intended purpose and to check the equipment that might be
connected to it.
The luminaire can under no circumstances be modified.
ADB will not assume any responsibility in case of damage
resulting from modications made to the luminaire.
This luminaire is a piece of professional equipment designed
for easy and simple use. Nevertheless, always refer to
qualified personnel for any installation or repair work.
Important Remark
Power supply cables and other connections are essential for
your equipment and contribute greatly to a safe and trouble free
operation.
• Always hold the plug when disconnecting a cable, never pull
the cable.
• Never use cables or connectors in bad condition, check
them before installation and periodically thereafter.
• Never tie power supply and data cables together.
6
Spotlight Description
1 Manoeuvring handle
2 Suspension points
3 Lock for the door
4 Door hinge
5 reflector
6 Front door
7 Terminal box
Accessories
Description
• Suspension cable
• Safety cable
Photometric Data
Ref.
CS/HT2250
CAS 120/N
Lighting Technologies