Uline H-12396 Mode D'emploi

H-12396
MONITOR RISER –
POWERED
TOOL NEEDED
Allen Wrench
A
Top Panel x 1
NOTE: Check that all parts are included.
1. Place top panel (A) on non-marring surface with
holes facing up. (See Figure 1)
2. Attach leg frame (C) on one side of the top panel (A)
using two M6 x 16 mm bolts (E). Attach leg frame
with power (B) on opposite side using two
M6 x 16 mm bolts (E). (See Figure 1)
NOTE: Ensure outlets are facing out when
installing leg frame with power. (See Figure 2)
3. Attach USB cord (D) to the inner panel of the
power center. (See Figure 1)
4. Set monitor riser upright. Assembly is complete.
(See Figure 2)
PAGE 1 OF 3
1-800-295-5510
uline.com
PARTS
B C
Leg Frame with Leg Frame x 1
Power x 1
ASSEMBLY
D
USB Cord x 1
Figure 1
C
Figure 2
Outlets
Para Español, vea página 2.
Pour le français, consulter la page 3.
E
M6 x 16 mm Bolt x 4
E
B
D
A
1225 IH-12396