General Characteristics - IGNIA LIGHT I0318 Manuel D'installation Et D'entretien

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up. Keep this manual for future reference.
To achieve optimum performance of the OnLED NIQ projector, follow the instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following accessories are included inside the box:
QUICK COUPLING OnLED NIQ
Models : I0318
• Unit floodlamp
• Decorative cover
• O'ring
• Installation and maintenance manual
• Manual for electrical connection

2. GENERAL CHARACTERISTICS:

This projector has been designed to be used fully submerged underwater in fresh water SPAS. It is a Class III electric
apparatus with very low safety voltage.
The projector complies with IPX8 degree of protection (resistance to penetration of dust, solid bodies and humidity) at a
nominal immersion depth of 2 m.
This projector complies with international safety standards for lights, especially the EN 60598-2-18 standard: LIGHTS
PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components
which have been inserted or handled at locations other than its own premises.
3. INSTALLATION:
• In order to clearly light a pool it is recommended to install a projector every 5 m
which are especially deep, a projector is required for every 10 m
• In order to prevent glare, the projectors should be installed so that they face away from the residence or usual view of
the swimming pool.
• In the event that lighting is used in training or competition pools, the projectors should be installed on the sides to prevent
glare on the swimmers.
• To avoid the need to empty the pool to change the lamp, we recommend that the projector be installed in areas which
are accessible from the upper edge of the pool.
Prior to installation verify that the gland seal has been fully tightened.
4. ASSEMBLY:
This projector is manufactured for installation in SPAS and metal or polyester bath-tubs.
The projector should be installed at approximately 400 mm below the water-level and in a place where it can not easily
be covered by the body of a person.
Concrete swimming pools
1. Make a siphon system with Ø50 PN10 piping. It should be higher than the maximum water level of the swimming pool.
It can also be placed in Ø63 PN6 or PN10 piping if it is glued to the 38818 or 38819 adapter respectively. Use PVC glue.
(Fig. 1)
2. Place the cable.
3. Press the projector in position.
4. Make sure you leave enough cable to be able to remove the projector to the edge of the pool in the event of an ano-
maly. (Fig. 2)
OnLED NIQ FOR SPAS
Models : I0319
• Unit floodlamp
• Decorative cover
• Butt joint
• Nut
• Installation and maintenance manual
• Manual for electrical connection
2
3
of water volume.
2
of water surface. In swimming pools