Télécharger Imprimer la page
Fortin EVO CAN Addendum
Fortin EVO CAN Addendum

Fortin EVO CAN Addendum

Nissan cube 2009-2010; schema de branchement suggere

Liens rapides

www.fortinbypass.com
1 / 6
Page
CUBE
PUSH
START
NISSAN
CUBE
WIRING COLOR | COULEUR DE FIL
POLARITY
DESCRIPTION
POLARITÉ
Security LED
CAN Bus (High)
CAN Bus (Low)
12 Volts 1
12 Volts 2
Ignition 1
Ignition 1
Acceossory 1
Accessry 2
Starter 1
Starter 1
Starter 2
Emergency Brake
Neutral Safety Switch
Lock & Arm
Unlock & Disarm
Push Button
Door Pin FL
Automatic Key Take Over:
Automatic Key Take Over:
proximity, the module will automatically trigger the Push-To-Start button and activate the vehicles ignition. The driver does
proximity, the module will automatically trigger the Push-To-Start button and activate the vehicles ignition. The driver does
not need to manually press the Push-To-Start button.
not need to manually press the Push-To-Start button.
est ouverte après avoir démarré le véhicule
ouverte après avoir démarré le véhicule
automatiquement l'ignition. Le conducteur n'a pas à appuyé sur le bouton
l'ignition. Le conducteur n'a pas à appuyé sur le bouton
Rev. 20110418
ADDENDUM - SUGGESTED WIRING CONFIGURATION
2009-2010
COLOR | COULEUR
Red / Yellow
Blue
Pink
Yellow
Pink
White / Red
Brown
Yellow / Black
Brown / White
Brown
Blue / Red
Light Blue
Light Blue
Brown
White / Black
White / Red
Blue/Orange
Brown / Yellow
When the door is opened after the vehicle has been remote-started and the SmartKey is in
When the door is opened after the vehicle has been remote-started and the SmartKey is in
Prise en charge du mode continue du véhicule:
Prise en charge du mode continue du véhicule:
à distance
à distance
et que la clé
Push-To-Start
WEB UPDATE | MISE À JOUR INTERNET
SCHÉMA DE BRANCHEMENT SUGGÉRÉ
Parts required
1-5x 1A Diodes
1-3x SPDT Relays
Functional if equipped | Fonctionnelle si le véhicule en est équipé.
LOCATION | EMPLACEMENT
BCM
40 pin connector
OBDII connector or BCM Connector
OBDII connector or BCM Connector
BCM
Black Connector
IPDM-E/R Under Hood
BCM
White Connector
BCM
White Connector
BCM
White Connector
BCM
White Connector
IPDM-E/R Under Hood
BCM
White Connector
IPDM-E/R Under Hood
Emergency Brake
IPDM-E/R Under Hood
BCM
White Connector
BCM
White Connector
BCM
40 pin connector
BCM
White Connector
et que la clé
SmartKey est a proximité le module
SmartKey est a proximité le module
.
Push-To-Start
.
1
23
Pièces requises
1-5x 1A diodes
1-3 Relais
Pin 38
Pin
22
Pin
21
Pin
15
Pin
32
Pin
33
Pin
25
Pin
35
Pin
34
Pin
13
Double pulse
Pin
14
Pin
31
Autolight Shutdown Pin
7
Lorsque la porte la porte
Lorsque la porte est
active automatiquement
active
loading

Sommaire des Matières pour Fortin EVO CAN

  • Page 1 www.fortinbypass.com WEB UPDATE | MISE À JOUR INTERNET 1 / 6 Page Rev. 20110418 CUBE ADDENDUM - SUGGESTED WIRING CONFIGURATION SCHÉMA DE BRANCHEMENT SUGGÉRÉ PUSH START Parts required Pièces requises 1-5x 1A diodes 1-5x 1A Diodes 1-3 Relais 1-3x SPDT Relays Functional if equipped | Fonctionnelle si le véhicule en est équipé.
  • Page 2 Remote Remote Cut off one plug of the 4 Pin Starter/Alarm Starter/Alarm with Data-Link connector Démarreur à the Fortin Data-link distance/alarme Connect the Red wire to +12V protocol. Démarreur à Connect the Black wire to distance/alarme Red | Rouge +12V...
  • Page 3 CONNECTEUR NOIR - 40 PINS CONNECTEUR NOIR - 15 PINS CONNECTEUR BLANC - 40 PINS Copyright © 2010, Copyright © 2010, Copyright © 2010, Copyright © 2010, Fortin Auto Radio Inc Fortin Auto Radio Inc Fortin Auto Radio Inc Fortin Auto Radio Inc...
  • Page 4 Drive: 0 Volts moisture otherwise damage may occur. Protégez le Relai des intempéries. L'eau peut causer des dommages. C C opyright © 2008, FORTIN AUTO RADIO INC IPDM-E/R WHITE CONNECTOR WHITE CONNECTOR WHITE CONNECTOR Copyright © 2010, Copyright © 2010, Copyright ©...
  • Page 5 5 / 6 Ce Guide peut faire l’objet de changement sans préavis. www.ifar.ca pour la récente version. Page PROGRAMMING PROCEDURE | PROCÉDURE DE PROGRAMMATION Pressez le bouton de programmation en Press and hold the programming button insérant le connecteur 4 pins (Data-Link) while inserting the 4 Pin (Data-Link) dans le EVO-CAN.
  • Page 6 Only a computer safe logic probe or digital multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in every case is the sole responsibility of the installer performing the work and FORTIN ELECTRONIC SYSTEMS assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly or any other way.