Automatic Force Set Up - Liftmaster 98032 Mode D'emploi

Adjustment
4

Automatic Force Set Up

Once both the up and down positions have been manually set, the Safety Reversing Sensors will reconnect and become
operational. Then, the opener will enter a force-sensing operation by automatically moving the door open and close. The
garage door opener will sound an audible and visual alert before automatically opening and closing the door. The garage door
opener will beep three times, confirming that the Automatic Force Setup completed successfully. Adjustment is complete.
If you hear one long beep after the door attempts to move, then the Automatic Force Set Up has not completed
successfully. Please start over at step 1 of Program the Travel.
Manually Programming the Adjustment Settings for Model 98032
1. Press the adjustment button.
• The up and down arrows will turn on solid.
2. Select the correct drum profile by toggling between the arrows.
3. Once the correct drum profile is selected, press and release the adjustment button.
• A beep will be heard, and the up arrow will start to flash.
4. Press and hold the up arrow until the door reaches the desired open position.
5. Press and release the adjustment button.
• The opener will start to beep, and the work light will start to flash.
• While the opener is beeping and flashing press and release the adjustment button. The beeping and flashing will stop, and the
down arrow will start to blink.
6. Press and release the adjustment button.
7. Press the adjustment button.
• The opener will start to beep, and the work light will start to flash.
• The opener will open a foot and a half and stop. Then it will start to beep and flash then close.
• Once it reaches the floor the opener will start to beep and flash. The door will then open to the desired open position.
• The opener will start to beep and flash, then it will close.
• Once the down position is reached you will hear three quick beeps and the down arrow will stop flashing.
8. Test the opener using the Wall Control or Remote Control.
• If the door travels as desired, the adjustments have been programmed.
• If the door does not travel as desired, repeat the steps.
22