Program The Travel - Liftmaster 98032 Mode D'emploi

Adjustment
3

Program the Travel

Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
• Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
• After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
1-1/2 in. (3.8 cm) high object (or 2x4 laid flat) on floor.
NOTE: While programming the travel, the UP and DOWN buttons can be used to move the door as needed. During the
Automatic Force Setup, the door will automatically open and close.
1
Press and hold the UP Button until the door is in
the desired UP position.
2
Once the door is in the desired
UP position, press and release
the Adjust Button to start the
Auto Program Limit Sequence.
The garage door opener will
sound an audible and visual
alert before automatically
opening and closing the
door. The opener will automatically determine
the DOWN position of the door. The garage door
opener will sound an audible and visual alert
before automatically opening the door partially and
closing the door again to refine the DOWN position.
Program the Travel is now complete.
NOTE: If the garage door opener remote work light
flashes 5 times, then programming has timed out and
the door travel limits have not been set. Please restart
the program the travel process.
21