Rohde & Schwarz R&S NRT-Z14 Manuel D'utilisation page 11

Putting into Operation
Click Finish. The wizard for finding new hardware will start a second time:
Click Next. If the first part of the installation was completed successfully, the following window will
appear:
Click Finish to conclude the installation of the device drivers. Now connect the sensor to the R&S
NRT-Z5 interface adapter and test the function using the Windows
1.4.2 Checking and Changing the Virtual COM Port
To check the assigned virtual COM port and to change it if necessary, proceed as follows:
Select Control Panel or Settings – Control Panel in the Windows™ start menu
Select the System icon
Select the Hardware tab
Click the Device Manager button to start the device manager
Open the Ports (COM & LPT) item. The assigned COM port is indicated directly to the right of
R&S NRT-Z5:
To change the assigned COM port, double-click R&S NRT-Z5 (or right-click and select Properties
in the context menu)
1081.1309.02 1.4
R&S NRT-Z43/Z44
user interface (chapter 2).
E-8